Saab 95 1967, Руководство по обслуживанию

Страница: 146 / 610

4. Turn the crankshaft until the mark on the crank—
shaft gear faces the camshaft.
5. Pass the camshaft gear onto the camshaft 50 that
the mark coincides with the mark on the crank-
shaft gear. Secure the camshaft gear with a re-
taining bolt and washer.
$1142
INSTALLATION
MARKS, TRANSMISSION GEAR
6. If this job is done in the car, it is nearly always
necessary to renew the part of the oil pan gasket
that rests against the transmission cover. The cor-
responding part of a new gasket must then be cut
off with a sharp knife, carefully fitted, and glued
to the rest of the gasket.
7. Apply a thin coat of sealing compound to the moun-
ting surfaces of the transmission cover. Position
the gasket. Put on the cover and center it with tool
78 62 147 until all the bolts have been tightened.
Sim
LATION
OF TRANSMISSION COVER
INSTAL
1. Transmission cover
2. Centering arbor 78 62 147
8
Connect the water hoses to the water pump,
9. Lightlv oil the pu||ey shaft. Put on the pulley and
tighten it with a bolt and washer. .
10 Insert the ru cove In the rear main
bearing cap-
11 Apply a coat of Sealing compound to the two cor-
ner joints where the transmission Cot/er, the inter.
mediate plate and the edges of the all pan meet,
Position the oil pan gasket on the block and insert
the two tabs on the cork gasket under the recesses
in the rear bearing cap rubber seal.
oil pan. Position the two
th the rubber washers at the rear balance
bber seal in the 9"
12. Install and secure the
bolts wi
shaft bearing.
FITTING THE TWO BOLTS WITH RUBBER WASHERS
13. Lubricate the tappets and their bores with engine
Oil and Install the tappets in the same sequence as
they were originally fitted.
14. Install the cylinder head gaskets. The gaskets are
marked "Front" and "Top".
25
mo
mf‘
0»—
zx
czo
on:
>u.