Saab 95 1967, Руководство по обслуживанию

Страница: 171 / 610

4' if the measured amount of fuel does not lie w‘th'
the stipulaIEd tolerances, adjust the acceleratir't m
setting by bending or straightening the connectsI pump
lever- Bending the lever increases the pu 'ng'md
Conversely, If the lever is traightened out Iihel-‘acitv. ”
capacity is reduced. pump \Q’
U“
Slur
ADJUSTMENT OF MEASUREMENTS “A” AND "B"
SETTING OF AUTOMATIC CHOKE
Normally, the functioning of the automatic choke should
not be altered in any way. The setting mark on the ther-
mostatic spring housing to be in line with the center mark
on the automatic choke housing. The free end of the
thermostatic spring to be fitted in the center slit of the
thermostatic spring lever.
sane
CONNECTING
ROD LEVE R
SETTING OF FLOAT CHAMBER VALVE
I. The measurement “A” = 0.32—0.40 in. (8—10 mm) is
measured with the throttle valve wide open.
2. The measurement "B" = 0.008—0.012 in. (0.2—0.3
mm) is measured with the throttle valve fully closed.
l
l
MEASURING
DIMENSIONS "A" AND
A = 0.32—0.40 in. (8—10 mm)
B = 0.008—0.012in.(0.2—0.3 mm)
LOCATION OF THERMOSTATIC SPRING HOUSING
5 obtained by bend-
wards the ten-
"B" is obtained
3- Adjustment of measurement "A" '
ing the lower part of the lever stop to
Si0n pin. Adjustment of measurement
by bending the lever at the PUSh rod.
._- .8 231 —7