Saab 95 1967, Руководство по обслуживанию

Страница: 402 / 610

Differential
37. Refit the differential assembly and spacers, and
tighten the bearing cap screws with a torque of
40 Nm (28 ft.lb., 4 kpm). NOTE! Fit the short
screws in the small bearing cap.
NOTE
If the pinion shaft setting has been altered or parts
of the differential assembly renewed, always check
the side clearance of the bevel gear and adjust if
necessary. See section 473.
38. Refit the speedometer drive gear.
39. Coat the top cover with sealing compound and
check that the three gear shift forks in the transmis-
sion case as well as the dogs and catch in the cover
are set at the neutral position. Then fit the cover
on the transmission case.
GEAR
SHIFT MECHANISM AND CATCH IN TRANSMISSION
CASE COVER
40.
41.
42.
43.
471—10
M
nction of the gear shift mechanism,
e freewheel hub and an undamaged
erted in the primary shaft/
hub should engage firmly
tool 87 90 305
Check the fu
Check that th .
needle bearing are Ins
freewheel sleeve. The
when twisted to the right. Use
for assembling-
NOTE
shaft seal and drive shaft seals and
y. Fit the seals so that the dust
Check the clutch
renew as necessar .
guard lips face outwards. Fill the spa
lips with chassis grease.
cc between the
Coat the sealing surface of the clutch housingwith
sealing compound and attach the clutch housing to
the transmission case. Turn the clutch shaft so that
it clears the differential. Make sure that the clutch
shaft is not subjected to lateral stress and that the
freewheel hub engages with the splines of the clutch.
Check the sealing rings in the clutch housing and
mount the two output shafts, taking care to avoid
damaging the sealing rings or dislocating the retain-
ing springs.
Smear the clutch shaft splines with graphite grease
and fill the unit with transmission oil.