Saab 95 1967, Руководство по обслуживанию

Страница: 502 / 610

Removal of twist stop
1. Engage lst gear, thus providing access to two clamp-
ing screws on the twist stop through the holes (2) on
the bottom of the steering column stand. Undo these
internal hexagon screws with a 3/16" spanner.
2. Engage reverse gear and turn the ignition key to the
locked position enabling the stop screw which
holds the twist stop to be backed off through the low-
er hole 2, in the steering column stand.
S 352
GEAR LEVER LOCK, CUT-AWAY VIEW
1. Clamping screw
2. Adjusting hole
3. Twist stop
4. Gear shift shaft
5. Steering column stand
6. Gear shift lever
3. The gear positions can now be adjusted by moving
the steering column stand in the ordinary way. If the
ignition key is turned to position G, thereby releasing
the twist stop, the gear shift mechanism can then be
dismantled.
NOTE
The clamping screws of the twist stop are always
accessible when 1st gear is engaged and the stop
screws when reverse gear is engaged.
641—12
Adjustment
of twist stop
After adjustment of gear positions, readjustment of the
twist stop is called for. The procedure is the following:
1. The twist stop is marked on the side that is to face up.
wards towards the steering wheel. The marking shows
for which version the twist stop is designed, e,g_ v.4
means left hand drive, 4-speed.
2. Engage reverse gear and push the twist stop up. At the
same time, turn the ignition key to the locked posi-
tion (L) and check that the lock plunger finds its posi-
tion in the twist stop.
3. The twist stop now hangs on the lock plunger. Move
the twist stop up about 0.08 in. (2 mm) and tighten
the stop screw slightly. Note! Do not tighten the screw
up too hard, its purpose being merely to hold the twist
stop during adjustment.
4. Turn the ignition key to position G and engage lst
gear, enabling two clamping screws on the twist stop
to be tightened. Then engage reverse gear and slacken
the stop screw. Return to lst gear and tighten the
clamping screws permanently. Now engage reverse
gear again and tighten the stop screw enough to pre-
vent it from working loose.
ADJUSTMENT OF TWIST STOP
Natal On right hand drive cars there is a spring on the
gear shift shaft which serves as a reverse catch. This spring
must be In place when the twist stop is adjusted.
m Fem 197/