Saab 95 1967, Руководство по обслуживанию

Страница: 258 / 610

Adjustment agalnst panel or wall
1. Check the tire pressure: and place the car, loaded in
the same way as normally, on a flat surface and at a
distance of 16 ft. 6 in. (5 ml from the panel.
2. Up to and incl. model 1973: Remove the decor frame
in order to uncover the adjustment screws.
3. Mark the height of the headlight center above the
ground on the panel.
4. Switch on the headlights with the beam dimmed and
mask one light.
5. Check and adjust the beam so that the horizontal part
of the dividing line between light and darkness lies
2.0" (50 mm) below the measured dead center of the
headlight and to the left of the center (or to the right
in the case of a left asymmetric beam). The sloping
part of the light dark dividing line should lie fully to
the right of the mark (to the left for a left asymmetric
beam) and should thus meet the horizontal part imme-
diately below the dead center.
ALIGNMENT. TOWARDS SCREEN
H a Height of headlight center above ground
A - 11.3 in. (288 mm)
B - 2.0ln.(60 mm)
6. Check the beam of the other light in the same way.
7. Check that the high beam has an even spread. If the
light pattern is irregular or if any difficulty is experi-
enced in setting the dimmed beam correctly, check
that the bulb is properly mounted or, if necessary, fit
a new bulb.
PARKING AND STOP LIGHTS
General, up to and incl. model 1968
hts are mounted in the front panel
the direction—indicating flashers.
are integral with the stop lights
The front parking Iig
and are combined wrth
The rear parking lights
' ' ' hts.
nd flashers In the tail Iig ' .
The stop light switch is located In the engine compart
ment on the master brake cylinder.
FLASHER AND PARKING LIGHT, FRONT, STANDARD AND
EXPORT VERSION
TAIL
LIGHT, SAAB 95
1. Stop and flasher light
2. Parking light
351
—8 m