Saab 95 1967, Руководство по обслуживанию

Страница: 465 / 610

HANDBRAKE SYSTEM
GENERAL
The mechanical handbrake acts on the rear wheels only.
When the handbrake lever is pulled, the movement is
transmitted by the handbrake cables to levers on the rear
wheel brakes. These actuate the brake shoes meChanically
and press them against the brake drums.
HANDBRAKE CABLES
The permanently lubricated handbrake cables comprise
inner steel wires in plastic coated spiral sheathing, led
through a sleeve under the backrest cushion of the rear
seat. The cables are fitted with protective grommets where
they pass through panels. The cables are clamped to the
rear axle, the inner wires being attached to the back plate
levers by means of clevis-and-pin connections. A return
spring is fitted between the clevis and the spiral sheathing.
Up to and incl. model 1970
As from model 1971
Removal
1. Remove one of the front seats and the rear seat cush-
ions. Jack up the car.
2. Remove the rear wheel.
3. Back off and remove the adjusting Wt under th
brake lever.
4. Pull the cable sheathing out of the sleeve under the
rear seat cushion.
5. Remove the clamps used to hold the cable to the rear
axle.
6. Remove the pin holding the clevis on the brake lever.
. Ease the grommet out of the inclined panel in the rear
axle tunnel.
8. Pull out the entire brake cable rearwards.
e hand-
\I
Installation
1. If the grommet in the rear axle tunnel has been re-
moved, ease it on to the cable.
2. Pass the cable, threaded end first, up through the in-
clined panel in the rear axle tunnel and on through
the sleeve under the rear seat to the handbrake lever.
Make sure that the grommet in the front inclined pan-
89101112
itW
S2950
HANDBRAKE LEVE R COMPONENTS
8. Cotter pin or circlip
9. Pin
10. Adjusting nut
11. Cable pin
12. Threaded wire rods
13. Pawl rod
14. Ratchet
1. Release button
2. Nut
3. Return spring
4. Washer
5. Handbrake lever
6. Pawl
7. Spacer sleeves
Febr 1977
551—1