Saab 95 1967, Руководство по обслуживанию

Страница: 484 / 610

IO.
Tighten the nut and shaft seal using hook wrench
78 40 200. Lock the nut.
Pack the space between the lips and the inner seal
with chassis grease.
Mount the outer drive shaft (with intermediate
drive shaft already mounted) in a press and press
on the steering knuckle housing and bearing. Use
sleeve 78 41 067 locating on the inner ring of the
bearing.
PRESSING THE KNUCKLE HOUSING AND BEARING ONTO
THE OUTER DRIVE SHAFT
Tool 78 41 067
II.
12.
13.
14.
15.
16.
631 —4
Fit the two clamps on the outer rubber bellows and
the clamp for the inner bellows at the shaft.
If the needle bearings have been removed, lubricate
them with Saab special grease and mount them on
their journals. Fit the cover 73 23 736 to protect
the needle bearings, and pass the drive shaft in
through the wheel house. Make sure that the inner
driver is clean and that it has been packed with
Saab special grease. Then reassemble the inner
universal joint and tighten the clamp round the
rubber bellows.
Refit the steering knuckle to the steering arm and
lower ball joint. Remember to provide lock plates
at the screws, and to secure these.
Refit the hub and the brake disc, followed by the
brake housing and friction pads. Secure the bolts
with lock plates.
Refit the wheel and lower the car. Tighten the axle
nut to a torque of 180 Nm (130 ft.|b., 18 kpm), and
secure.
Refit the hub cap.
.
Jack up the car and r
. If the upper ball joint
WARNING
turned to their position
The friction 133
near the brake disc.
pump repeatedly w:
this respect will resu
To ensure correct positioning,
brake pedal. Neglect in
emove the wheel. Wash the ban
' Ily.
' ' ad acent parts carefu
JOIN and is to be changed, compress the
spring with the aid of the spring scissors 89 95 847
and spring cups.
WAR N l NG
Unconditionally, the spring scissors must be fitted
with the cups fitted in the way shown by the flg.
POSITIONING OF SPRING SCISSORS AND SPRING CUPS,
LEFT SIDE