Saab 95 1967, Руководство по обслуживанию

Страница: 129 / 610

28' Install the 0“ pump, Tighten the actual Du
first and then the suction line bolt. mp bolts
29, Insert the rubber seal in th .
bearing cap. e groove in the rear main
30. Apply a coat of sealing compound to the two C
ner joints where the transmission Cover, the int:-
mediate plate and the edges of the oil pan meet
Position the 0“ pan gasket on the block, and insert
the two tabs on the cork gasket under the recesses
in the rear bearing cap rUbber seal.
FRONTTOP
D WEN OBEN
INSTALLATION
OF CYLINDER HEAD GASKET
34. Install the complete cylinder heads, insert the bolts
and tighten them in the sequence indicated to the
correct torque, tightening in three stages as per the
following table:
N_m kp_m Lib-
I. 54 5.5 40
2. 69 7.0 50
3. 93 9.5 68
IMPORTANT
To ensure effective sealing, the bolts must be tight-
ened in three stages to the prescribed torque in the
INSTALLATION OF OIL PAN GASKET
sequence indicated.
31.
Install and secure the oil pan. Position the two
bolts with the rubber washers at the rear balance NOTE
The outer, rear bolt for the righthand cylinder head
shaft bearing.
is specially adapted for the engine earth cable.
IIII.
’3
F?
—
’
’I
—d
.-
.d
.—
.‘
53:.
32-
Lubricate the tappets an
oil and install the tappets in
they were originally fitted.
33- lnstaii the cylinder head gal
marked “Front” and "TOP
210—9
skets. The gaskets are