Saab 95 1967, Руководство по обслуживанию

Страница: 147 / 610

15. Install the complete cylinder heads, insert the b I
and tighten them in the sequence in ‘ 0 ts
IMPORTANT
To ensure effective sealing, the bolts must be tigh-
tened in three stages to the prescribed torque in
the sequence indicated.
TIGHTENING SEQUENCE, CYLINDER HEAD BOLTS
NOTE
The outer, rear bolt for the righthand cylinder head
is specially adapted for the engine earth cable.
16-
Apply sealing compound to the surfaces of the cyl-
inder heads as shown in the figure. Install the in-
duction manifold gasket and make sure that the
protruding part of the righthand cylinder head gaS-
ket enters the aperture in the induction manifold
gasket.
17.
Install the induction manifold. Tighten the screws
and nuts with the tightening torque specified in
group 0.
IMPORTANT
To ensure effective sealing, the bolts must be tight'
ened in two stages to the prescribed torque in the
sequence indicated.
TIGHTENING SEQUENCE’ INDUCTION MANIFOLD BOLTS
18. Dip the push rod ends in engine oil and install the
push rods in their original positions in the tappets.
19. Lubricate the ends of the rocker arms with engine
oil and install the oil return plates and rocker arm
assemblies. In so doing, align the push rods under
the rocker arms and check that the oil return plates
are not in contact with the valve springs. Secure
the rocker arm assemblies by alternately tightening
the two screws.
20. Adjust the valve play. See the section "Valve ad-
justment".
21. Install the distributor in the engine block. See group
3. section 342.
22. Install the fuel pump push rod, the gasket and the
pump. Install the push rod with the same end against
the cam as originally.
23. Insert a new gasket in the valve cover. Press the
clamp ends of the gasket into the notches in the
cover.
NOTE
Before the valve covers of the cylinder heads are re-
fitted, the lubrication of the rocker shaft must be
checked with the engine running.