© REA Elektronik GmbH, Teichwiesenstraße 1 D-64367 Muehltal
REA VeriCube Operating Manual Version 2.16 – 11/2020
Page 118 of 119
25.4
Manager’s Obligations
The operator
commits to have only persons working on the REA VeriCube who:
Have been instructed in basic regulations on workplace safety and
accident prevention.
Have been trained in the handling of the REA VeriCube
Have read and understood this manual and in particular the chapter on
safety and warnings, and have confirmed that by their signature.
25.5
Obligation of the user
All persons working with the REA VeriCube commit:
to observe the basic regulations on workplace safety and accident
prevention.
To read and observe this manual and in particular the chapter on safety
and the warnings
25.6
Intended use
The REA VeriCube is a measuring device that can only be used for quality
control of printed barcodes and matrix codes or for reflectance measurements.
It is a measuring device, that must always be connected to a PC via a network.
With the device and its camera module, the optical measurement of the code
is done. On the PC, the supplied remote control and analysis software is
running. A test reports is shown on the display, but can also be printed.
Any other use or use going beyond the applications described above, is
considered to be improper use. The liability of REA Elektronik GmbH is
explicitly excluded for any resulting damages.
intended use includes also:
Following all the instructions in this manual especially the safety
instructions.
The regular review of device status in terms of intact
o
Connectors / plugs
o
Cables
o
Housing
o
Security components
Regular monitoring that the equipment is in good condition.
A device that is damaged, must not be put into operation in order to prevent injury
or damage.
