Phason Supra-RS, Руководство пользователя

Страница: 113 / 152

Appendix A: Glossary
21040012 113
humidity
compensation
The adjustment the Supra makes to compensate for high humidity levels.
For more information, read
Programming the humidity
on page 73.
humidity factor The amount of effect on the ventilation rate at high humidity levels; 0 is little
effect, while 10 is full effect.
For more information, read
Programming the humidity
on page 73.
humidity zone The zone the humidity sensor (if connected) is assigned to. A humidity sensor
can be assigned to only one zone.
For more information, read
Selecting a humidity zone
on page 60.
hysteresis Hysteresis helps prevent damage to the relays, variable stages, and the equipment
connected to them by preventing the stages from switching on and off rapidly
when the temperature is hovering close to the
set point
. For example, a
household thermostat might turn on a furnace at 68 °F when the house is cooling
down, but turn it off at 72 °F when the house is warming up. The difference
between these two values is the hysteresis.
For more information, read
Configuring hysteresis
on page 58.
idle at
Idle at
is the temperature at which a variable cooling stage is at its minimum
speed.
For more information, read
Programming variable stages
on page 75.
idle speed
Idle speed
is the percentage of full speed a variable stage fan is at when the
temperature is between the
off at
and
idle at
temperatures.
For more information, read
Programming variable stages
on page 75.
inlet actuator See actuator
inlets Inlets are shutter-like devices mounted on a wall or ceiling that control airflow in
a building.
minimum
duration
Minimum duration
is the minimum amount of time and alarm condition must be
present before the Supra signals an alarm.
Minimum duration
prevents alarms
from activating when the temperature rises or drops for just a few seconds.
For more information, read
Programming alarm settings
on page 90.
minimum idle See idle speed
minimum
position
Minimum position
is the percentage an actuator will be open when the
temperature is at the
minimum set point
.
For more information, read
Programming actuator relays
on page 78.