Phason Supra-RS, Руководство пользователя

Страница: 118 / 152

Appendix B: Troubleshooting
118 Phason
Alarm message Possible cause Possible solution
Probe 1 Absent
Probe 2 Absent
Probe 3 Absent
Probe 4 Absent
An active temperature probe has
disconnected.

The next active Probe will be used. If
Averaging is ON, the defective probe
will be excluded from the average.

Reconnect the temperature probe. The
control should recover automatically.

Read Connecting temperature probes
on page 31.
Actuator 1 Jam
Actuator 2 Jam
The Supra is attempting to open
or close an inlet or other element
operated by an actuator, and has
not received the correct response
from the positioning motor.

Check the element controlled by the
actuator to see if it is mechanically
stuck.

Check the feedback wires for damage.

Read Determining correct actuator
feedback wiring on page 121.
Error
for a relay during the status display
You have configured an “open
relay” for an actuator or curtain,
but not a “close relay”.

Check the relay configuration and
configure the close relay.

Read Configuring the control stages
on page 46.
Low AC Line
Frequency
High AC Line
Frequency
The AC line frequency is outside
acceptable limits (±3 Hz at rated
line frequency). There is a danger
of damaging the control if this
condition persists.

Consult your local power company.

If using generator power, adjust the
generator frequency to 60Hz (or 50Hz).
Low Power Volt.
High Power Volt.
AC power supply is outside
acceptable limits (+10%/-20% at
rated line voltage).

Consult an electrician or your local
power company.
PC Comm. Alarm
The communication cable
between the Supra and the
computer is damaged or
disconnected.

Check the cable.

Verify that cable leads are properly
seated in terminal block.