Phason Supra-RS, Руководство пользователя

Страница: 23 / 152

What you need to know before installing the Supra
21040012 23
Zone temperature probe terminals (TEMP1 to TEMP 4) – connect the temperature probes for monitoring the zones
to these terminals.
Outdoor temperature probe terminal (OUT TEMP) – connect the temperature probe for monitoring outdoor
temperatures to this terminal.
Actuator feedback terminals
(ACT 1 and ACT 2) – connect the feedback from the actuators to these terminals.
Analog terminal
– connect a Relative Humidity Sensor here.
Alarm relay terminal
– connect an external alarm system or alarm siren to this terminal.
Pulse counter terminal
– connect a water meter with pulse output to this terminal.
Display cable socket
(CON3) – make sure the ribbon cable from the display is properly connected to this socket.
Communication socket (COM) – if you are using SupraWare to monitor and control a network of Supras, connect
the communication wiring to this socket. For more information, refer to the RS485-FD installation guide .
Saver socket (SAVER) – if you are using Supra Saver to store/load settings or a firmware updater to update the
Supra, connect it to this socket.
Address label
– the address of the Supra. If you are using SupraWare, you will need to know this number.
Expansion connector
(CON6) – if you are installing a 0 to 10 V DC expansion kit, connect it here.
Single-Phase Slave connections – if you are using Single-Phase Slave units to expand the capacity of your control
system, connect them here – VR3 for variable stage 3, VR4 for stage 4.
Contrast adjuster
(R69) – if you need to adjust the display contrast, use a small flat screwdriver to turn the knob.
Mounting the Supra
1. Select a location for the Supra. Make sure you have
enough cable and wire to reach all the equipment (fans,
heaters, misters, curtains, etc.) that you want to control.
2. Remove the screws from the front cover and then
swing it open.
3. Mount the enclosure to a wall using the four screws
provided with the control. Insert the screws into the
large holes in each corner of the box and tighten.
8
9
10
11
12
13
14
15
16
17
18
19
20