Phason Supra-RS, Руководство пользователя

Страница: 109 / 152

Performing diagnostic tests
21040012 109
5. Scroll to the line containing the relay for which you want to change the state (ON to OFF or
OFF to ON).
6. Press
ENTER
to move from left to right on a line until the relay you want to change is selected.
7. Press
+
or
–
to change the relay state and then press
ENTER
.
The relay state changes.
8. Repeat steps 5 to 7 for each relay you want to change.
9. Press
BACK
three times to return to the Main Menu.
The relays return to their normal, programmed settings.
While the Supra is in the Set relay stages display, the control will not operate the
equipment connected to the relays according to the programmed settings. When
you are finished testing, press
BACK
to return to the Diagnostics menu and return
the relays to normal operation.
Maintaining actuators
Because cables can stretch and equipment can come out of alignment (similar to tires on your car),
Phason recommends resetting the limit switches and calibrating your actuators at least once each
year. For more information, read
Calibrating actuators
on page 50.
Resetting the Supra to its factory defaults
When the Supra leaves the factory, it comes with default settings and configuration. When you
configure and program the Supra, you change its settings. Resetting the Supra erases all the
configuration and settings you programmed and then restores the settings to what they were when
the control left the factory.
For information about the Supra’s factory settings, see
Appendix C: Factory defaults
on page 122.

This function is very powerful; use caution when using it.

If you reset the Supra to its factory defaults, disconnect the power to all loads
and then reconfigure the control before restoring power to the loads.
To restore the factory default settings
1. From the Main Menu, select Factory Settings (7).
The display should look like the following example.