Panasonic LP-GS Series, Руководство по установке и обслуживанию

Страница: 35 / 190

35
2-3 Head Installation
WARNING
• Make sure that the power is turned OFF at installing. Failure to do so may
cause electrical shock.
• Install the product so that the laser beam path does not cross the eye height.
• The laser beam path shall be enclosed with protective enclosure and make
sure it is not exposed with direct light or reflected light.
„
Carrying head part
• To carry this product, wear the non-slip gloves. Hold the product with both hands. Do not hold the cables or connectors
at carrying.
• Do not touch the laser emission port on the bottom of the head. It may affect the marking quality badly.
• Carry this product as shown in the figure below.
Laser emission
port
Laser pointer
emission port
2-3-1 Installation direction
The head can be installed to up, down, left, and right directions. To install the product with the laser emission port facing
upward or horizontally, fix both right and left sides with the bottom surface (laser emission port side) used as installation
surface, by using screw holes on the head side.
ワㄐㄕㄊ㄄ㄆ
• When the product is installed with the laser emission port facing upward, dust generated during marking may attach to
the laser emission port, impairing marking quality and damage the product. Clean the laser emission port periodically
according to the head installation conditions and environment.
• Be sure to fix the bottom surface (the laser emission port side). Fixing it only on its side may cause damage on the
product.
• To install the product with the laser emission port facing upward or horizontally, fix the 3 surfaces: bottom and both
sides.
ME-LPGS-SM-8