Panasonic LP-GS Series, Руководство по установке и обслуживанию

Страница: 103 / 190

103
4-6-11 Registered characters/external offset marking
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T4 T4
T6 T2
T7
T2 T2
T5 T5 T5
T3 T3 T3
T1 T1 T1
SELECT 0 - 2 IN
(No.19-21)
D0 - D15 IN (No.3-18)
SET IN (No.2)
TRIGGER IN (X5)
READY OUT (Y5)
PROCESSING OUT (Y10)
SET OK OUT (No.28)
*1
*2
Data A
Data A
Data B
Data B
Data C
Data C
Item Time Remarks
T1 0.5ms or more After a lapse of 0.5ms or more from specifying SELECT 0 IN to SELECT 2 IN and D0 IN to
D15 IN, turn on SET IN (No.2).
T2 0ms or more Keep the input until SET OK OUT (No.28) turns on.
T3 2 to 510ms One-shot output. Set the output time on the system settings screen. There is a small
margin of error for the setting value.
T4 ― Time for data creation. It varies depending on the quantity of the setting data.
T5 2ms or more Keep the ON status for 2ms or more.
T6 0ms or more To input the next data number during the trigger processing, input SET IN (No.2) after
PROCESSING OUT (Y10) turns ON.
T7 ― • When the next marking data compiling has finished within the trigger processing time:
1ms or less
• When the next marking data compiling did not finish within the trigger processing time:
The remaining time of the marking data compiling (T4)
*1 : To specify the registered characters/external offset data number, set SELECT 0 IN to SELECT 2 IN as follows.
SELECT 0 IN (No.19): ON, SELECT 1 IN (No.20): OFF, SELECT 2 IN (No.21): OFF
*2 : Specify the data number of registered characters/external offset by using D0 IN to D15 IN. Refer to “4-3 Signals and
Details of I/O Connector” (P.78).
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• SET IN (No.2) for the registered characters/external offset is acceptable when the laser pumping is completed, and the
internal shutter opens.
• If you have configured the registered characters/external offset function, READY OUT (Y5) will not be output until the
data number and SET IN (No.2) are input.
• Enter the data number input and SET IN (No.2) every time for each marking trigger even there is no change to the
marking data.
• Close the shutter if you want to reset the data number after turning on SET IN (No.2).
• READY OUT (Y5) will be output even when specified the data number without any settings.
ME-LPGS-SM-8