Panasonic LP-GS Series, Руководство по установке и обслуживанию

Страница: 131 / 190

131
„
Marking - Image checking (when TIMING IN signal is used)
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T3
T1
T4 T5
T2
T6
T1
T7
T7
*1
TRIGGER IN (X5)
PROCESSING OUT (Y10)
CHECK NG OUT (No.35)
CHECK OK OUT (No.34)
PROCESSING END OUT (Y11)
SCRIPTING OUT (No.37)
TIMING IN (No.24)
TIMING WAIT OUT (No.36)
READY OUT (Y5)
Starting marking signal
Starting image checking signal
or
LASING OUT (Y20)
*1: CHECK OK OUT (No.34) / CHECK NG OUT (No.35) outputs before PROCESSING OUT (Y10) is turned OFF.
Item Time Remarks
T1 2ms or more Keep the ON status for 2ms or more.
T2 ― When TRIGGER IN (X5) is accepted, PROCESSING OUT (Y10) turns ON.
The output time of PROCESSING OUT includes the trigger delay time, operation time,
laser radiation time and laser marker internal processing time of the linkage devices.
T3 ― Laser radiation time. This varies depending on marking contents.
T4 ― Processing time of communication and linkage operations with the image checker.
For code checking or character checking, time for transferring the marking data to the
image checker by the laser marker is included.
T5 Max. 60 sec. Turn on TIMING IN within 60 seconds after TIMING WAIT OUT is turned ON.
If there is no input of TIMING IN within 60 seconds, an error occurs and trigger processing
is terminated due to the abnormality.
T6 ― Processing time of linkage operations with the image checker.
In this case, it is the following time.
• Time for reading by the image checker
• Time for transferring the checkup results from the image checker to the laser marker
T7 2 to 510 ms One-shot output. Set the output time on the system settings screen.
There is a small margin of error for the setting value.
ME-LPGS-SM-8