Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 86 / 158

80
Anchors In Storage Position
The anchors must be hung on the storage hooks
for transport.
1. Hang the anchors on the storage hooks
located on the tunnel cleanout plate.
2. Use the anchor in switch on the right side
console in the cab to remove the slack in
the anchor cables. Do not pull the cables
tight. If the cables are pulled tight, kinking
of the cables will occur.
3. Remove the clip pin holding the cable
guide to the welded pin on the frame.
4. Swing the cable guides up and pin in the
up position with the transport pin and clip.
Place Wheels Into Transport Posi-
tion
1. Lower the cab end lift jack enough to
slightly lift the wheels.
2. Press the “Align” switch on the switch
panel on the right side corner post.
3. Steer the wheels straight, front to back, ± 2
degrees.
4. Lower the cab end wheels to the ground by
lifting the jack all the way up.
5. Lower the engine end lift jack enough to
slightly lift the wheels.
Anchor and Guide In Storage Position
Pin & Clip
Clip On
Welded Pin
Cable Guide
Anchor
Align and Drive Switch
Press This End For Drive
Press This End For Align