Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 146 / 158

140
Clutch Oil and Filter
(Change oil & filter every 500 hours of
operation)
Refer to the clutch Installation & Maintenance
manual supplied with your bagger for additional
maintenance intervals and procedures.
Level Check:
Check the oil level in the reservoir daily. If oil is
low add Mobil 424 to bring the oil up to the full
mark on the reservoir. Do not ov
er fill.
Change the oil as follows:
1. Remove the drain plug from the valve in
the bottom of the clutch reservoir. The
reservoir is located next to the engine on
the feed table side.
2. Drain the oil from the reservoir. The reser-
voir holds approximately 20 gallons.
3. Close the drain valve and re-install the
drain plug. Dispose of used oil properly.
4. Remove the fill/breather cap on the reser-
voir and fill to the full mark. Fill with Mobil
424 oil only. Do not over fill.
Change clutch filter as follows:
1. Clean the area around the filter and filter
head. The filter is located on the side of
the engine frame on the feed table side
and toward the rear of the bagger.
2. Remove the filter from the filter head.
3. Lightly oil the filter o-ring with clean Mobil
424 oil. Fill the filter with clean Mobil 424
oil and install on to the filter head. Tighten
1/2 turn after initial contact. Do not over
tighten.
Clutch Reservoir Drain Valve
Clutch Reservoir Sight Gauge & Fill
Clutch Filter
Filter
Fill/Breather Cap
Full Mark
Add Mark
Drain Valve
Plug