Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 148 / 158

142
Change rotor planetary filter as follows:
Change the filter each time the planetary oil is
changed.
1. Locate the filter under the engine on the
feed table side of the machine.
2. Clean the area around the filter and the
filter head. Remove the filter and discard
properly.
3. Lightly oil the filter o-ring with clean syn-
thetic 80W-140 gear lube oil.
4. Fill the filter with clean synthetic 80W-140
gear lube oil and install on to the filter
head. Tighten 1/2 turn after contact. Do
not over tighten.
Rotor Planetary Filter
Feed Table Planetary Oil
(Change oil every 500 hours of operation
or annually)
Level Check:
Check the oil level daily. To check the oil level in
the feed table planetary, the feed table must be
lowered down to the operating position.
Locate the breather hose on the planetary. The
planetary is located at the lower end of the feed
table on the cab side. Clean the area around
the hose and remove the hose from the plane-
tary. The oil level should be at the bottom of the
breather hose hole.
If the oil is low, add synthetic 80W-140 gear lube
oil through the level hole until the level is at the
bottom of the hole.
Reassemble the breather hose to the planetary
and tighten securely.
Feed Table Planetary Level Check
Breather Hose
Level Port