Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 79 / 158

73
Bagging Procedure
Before Starting The Bagger
It is important that you set up a communication
system between the operator of the bagger and
all other persons involved with the bagging pro-
cess. By using the RED, YELLOW and GREEN
communication lights located at the engine end
and the cab end of the bagger. Sound the horn
before starting engine.
The communication lights are controlled by the
two rocker switches on the right side console in
the cab.
Communication Lights Engine End
Communication Lights Cab End
Bagger Start-Up Procedure
1. Using the warning procedure established,
warn all people to move away from the
bagger. After giving enough time for every-
one to move away, visually make sure the
area is clear.
2. Sound the horn, then start the engine
by turning the ignition switch to the start
position. Check all warning and diagnostic
messages on the System Monitor display.
Refer to the “Features and Controls” sec-
tion “In Cab Controls” for a detailed expla-
nation.
3. Start the rotor. Use the HPTO controller
on the right front cab post to start the rotor.
Press the engage/disengage button at the
lower left corner of the controller and hold
for 3 seconds. The controller will not en-
gage if activated with the engine rpm over
1100 rpm.
4. After the flashing green clutch engaged
LED turns solid, increase the engine rpm
to 1850 by using the throttle switch or the
high idle switch on the right side console.
Watch the System Monitor display for
engine rpm. Refer to the “Features and
Controls” section “In Cab Controls” for a
detailed explanation.
HPTO Clutch Controller
Engage/Disengage
Button
Clutch Engaged LED