Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 156 / 158

150
(In.) (In.) (Nm) (lb-ft) (Flats) (Turns)
3/8 1/2 8 6 2 1/3
7/16 9/16 12 9 2 1/3
1/2 5/8 16 12 2 1/3
9/16 11/16 24 18 2 1/3
3/4 7/8 46 34 2 1/3
7/8 1 62 46 1-1/2 1/4
1-1/16 1-1/4 102 75 1 1/6
1-3/16 1-3/8 122 90 1 1/6
1-5/16 1-1/2 142 105 3/4 1/8
1-5/8 1-7/8 190 140 3/4 1/8
1-7/8 2-1/8 217 160 1/2 1/12
Recommended
Turns To
Nut Size Tighten
Thread Across (After Finger
Size Flats Torque Value* Tightening)
Tightening Hydraulic Fittings
WARNING
Escaping fluid under pressure can penetrate the skin causing serious injury.
Relieve pressure before disconnecting hydraulic or other lines. Tighten all
connections before applying pressure. Keep hands and body away from pin
holes and nozzles which eject fluids under high pressure. Use a piece of card-
board or paper to search for leaks. DO NOT use your hand.
Tightening O-Ring Fittings*
1. Inspect O-ring and seat for dirt or obvious
defects.
2. On angle fittings, back the locknut off until
washer bottoms out at top of groove.
3. Hand tighten fitting until backup washer or
washer face (if straight fitting) bottoms on
face and O-ring is seated.
4. Position angle fittings by unscrewing no
more than one turn.
5. Tighten straight fittings to torque shown.
* Torque values shown are based on lubricated
connections as in reassembly.
Tightening Flare Type Fittings*
1. Chec k flare and flare seat for defects that
might cause leakage.
2. Align hose end with fitting before tighten-
ing.
3. Lubricate connection and hand tighten
swivel nut until snug.
4. To prevent twisting the hose, use two
wrenches. Place one wrench on the hose
end body and with the second wrench,
tighten the swivel nut to the torque shown
in this chart.
* Torque values shown are based on lubricated
connections as in reassembly.
(In.) (In.) (Nm) (lb-ft) (Flats) (Turns)
3/16 7/16 8 6 1 1/6
1/4 9/16 12 9 1 1/6
5/16 5/8 16 12 1 1/6
3/8 11/16 24 18 1 1/6
1/2 7/8 46 34 1 1/6
5/8 1 62 46 1 1/6
3/4 1-1/4 102 75 3/4 1/8
7/8 1-3/8 122 90 3/4 1/8
Recommended
Turns To
Tube Nut Size Tighten
Size Across (After Finger
OD Flats Torque Value* Tightening)