Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 154 / 158

148
7. Insert the end of the cable through the cable
anchor tube.
8. Slide the cable through the sleeve.
9. Unravel the cable and wrap around the knob
core. Keep the knob core halv es flush.
10. Tap the sleeve down on to the knob core
halves with a hammer.
11. Manually pull the cable tight from the out-
side.
12. Mark the cable as close to the fair lead as
possible (outer edge of pivot assembly)
13. Extend the cable 4 feet. Pull the cable while
extending.
14. Cut the cable at the mark.
15. Slide the cable through the center of the an-
chor. Install the cable stop on to the cable.
16. Pull on the anchor to secure the cable stop
in the nose of the anchor.
17. Retract the anchors. The anchors should be
tight in the sockets.
18. Repeat this procedure to replace the other
cable.
Cable Anchor Tubes
Cable, Knob Core Halves & Sleeve
Anchor Cable Adjustment
Most of the cable stretch will occur during the
first bag. Adjustment will need to happen prior
to the second bag. Also check each time the
anchors are fully retracted. The both anchors
must be tight against the sockets and feed out at
the same distance.
If adjustment is required:
1. The anchor will have to be removed from the
cable.
2. Fully extend the anchor cylinder, then retract
1 inch. Shut off the engine when measuring.
3. Manually pull the cable tight from the out-
side.
4. Mark the cable as close to the fair lead as
possible (outer edge of pivot assembly)
5. Extend the cable 4 feet. Pull the cable while
extending.
6. Cut the cable at the mark.
7. Slide the cable through the center of the an-
chor. Install the cable stop on to the cable.
8. Pull on the anchor to secure the cable stop
in the nose of the anchor.
9. Retract the anchors. The anchors should be
tight in the sockets.
Core Halves
Sleeve
Anchor Tube