Miller AG-BAG Professional LX1214, Руководство оператора

Страница: 52 / 158

46
Outside Controls - Manual
The bag boom and the bag pan can be operated
with the controls on the tunnel side of the ma-
chine near the engine or by plugging in a remote
control to give you more mobility.
All of the control levers on the machine are
spring loaded to return to the neutral position
when released.
The control levers operate the following func-
tions:
Boom Rotate In or Out: Use this control to
rotate the bag boom into position to properly lift
the tunnel extension into position and to position
the bag onto the tunnel.
Boom Up or Down: Lifts the entire boom arm
up or down for positioning of tunnel extension or
bag.
Boom Extension Out or In: Use this control
to extend the boom in or out to reach out farther
from the tunnel to position the bag on the tunnel.
Be sure the boom winch is out far enough to al-
low extension of the boom. If cable is not out far
enough, winch damage can result.
Boom Winch Up or Down: Use this control to
lower the winch cable down to pick up the bag
with the bag craddle and raise up into position.
Use also to lift and lower the tunnel extension
into position.
IMPORTANT: The bag boom is designed to
be used for positioning the tunnel extension
and to install bags onto the tunnel.
Bag Pan In or Out: This control will position the
bag pan in or out as required to properly position
the bag into the pan for bagging.
All of the above controls can also be operated
from the remote control. Refer to “Outside
Controls - Remote Control”. When the remote
control is used, the levers on the valve control
bank will move as the remote is activated.
IMPORTANT: When the remote control is acti-
vated, the wheel drive controls inside the cab
are locked out.
Machine Up or Down: This control is used
to lift or lower the engine end of the bagger by
lowering or raising the lift jack at the engine
end. This function can not be operated with the
remote.
DANGER
To prevent personal injury stay clear of hy-
draulic cylinder and lift jack pad when lower-
ing lift jack to the ground. Severe crushing
will occur.
Lift the lever up to lower the engine end lift jack
(raise machine). Push the lever down to raise
the engine end lift jack (lower machine). The
control is spring loaded to return to the center off
position when released.
Be sure to raise the lift jack completely before
moving the bagger and during bagging opera-
tion.
Outside Controls - Tunnel Side Engine End