Komatsu WA480-8, Руководство по эксплуатации и техническому обслуживанию

Страница: 348 / 440

REMARK
You cannot measure the exact oil level until 12 hours elapses after the engine is stopped because the oil
remains in various parts.
2.
Remove the cap of oil filler port (F).
3.
Pull out dipstick (G) and wipe the oil off with a cloth.
4.
Fully insert dipstick (G) into the dipstick pipe, then remove
it.
REMARK
Whenever inserting the dipstick, be sure to insert it into the
dipstick pipe.
The oil level should be between the H and L marks on dip-
stick (G).
5.
If the oil level is below the L mark, add oil through oil filler
port (F).
The following levels are marked on the dipstick.
(A): ENG STOP (Engine is stopped)
(B): ENG LOW IDLE (Engine is running at low idle)
6.
Remove inspection window (1) of the undercover.
7.
If the oil level is above H, drain the excessive oil through
drain plug (P), and then check the oil level again.
8.
If the oil is at the correct level, insert dipstick (G) in the dip-
stick pipe and tighten the oil filler cap.
Checking of the oil level must be done at “ENG STOP” position after 12 hours or more elapsed after the engine
is stopped.
The oil level can be checked when the engine is running at low idle as well. When checking in such condition,
perform the check as follows.
MAINTENANCE PROCEDURE MAINTENANCE
4-24