Keysight Technologies N9030B, Руководство по обслуживанию

Страница: 120 / 617

120 N9030B PXA Signal Analyzer Service Guide
Instrument Messages
Event Messages
–100 to –199, Command Errors
Err# Message Verbose/Correction Information
–100
Command error
There is a problem with the command. The exact problem cannot
be specifically identified.
–101
Invalid character
An invalid character was found in part of the command.
–102
Syntax error
An unrecognized command or data type was found, for example
a string was received for a command that doesn’t accept strings.
–103
Invalid separator
The command was supposed to contain a separator but we
found an illegal character. For example, the semicolon was
omitted after a command string.
–104
Data type error
We found a data type different then what was expected. For
example, numeric or string data was expected, but block data
was found.
–105
GET not allowed
A Group Execute Trigger was received within a program
message.
–108
Parameter not allowed
More parameters were received than were expected for the
command. For example, the *ESE common command only
accepts one parameter, so sending *ESE 0,1 is not allowed.
–109
Missing parameter
Fewer parameters were received than required for this
command.
–110
Command header error
This is a general error that is generated when a problem is found
in a command header, but we can’t tell more specifically what
the problem is
–111
Header separator error
We found an illegal character in a command where we expected
to find a separator.
–112
Program mnemonic too long
The command contains a keyword that is more than twelve
characters.
–113
Undefined header
The command meets the SCPI syntax requirements, but is not
valid in the current measurement environment.
–114
Header suffix out of
range
The value of a numeric suffix that is attached to a program
mnemonic makes the header invalid. (A suffix is usually units,
like Hz or DB.)
–115
Unexpected number of
parameters
The number of parameters received does not correspond to the
number of parameters expected.
–120
Numeric data error
An error was found in a data element that appears to be
numeric. The exact problem cannot be specifically identified.
–121
Invalid character in
number
A character was found that is not valid for the data type. For
example, an alpha in a decimal numeric or a “9” in octal data.
–123
Exponent too large
The magnitude of an exponent was greater than 32000.