Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Справочник по командам

Страница: 199 / 1488

path ds3 loopback
Syntax
path pathChannel ds3 ds3Channel loopback { local | network { line | payload } }
no path pathChannel ds3 ds3Channel loopback
[ no ] path pathChannel ds3 ds3Channel loopback remote
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Configures a loopback at the DS3 layer for a DS3 signal. This command applies to a
DS3 over channelized SONET interface. The
no version turns off the loopback.
Options
■
pathChannel —Number, in the range 1–2147483648, that identifies the path
■
ds3Channel —Number, in the range 1–3, that identifies the path
■
local—Loops the data back toward the router; on supported line modules also
sends an alarm indication signal (AIS) out toward the network.
■
network { line | payload }—Specify the line keyword to loop the data toward
the network before the data reaches the framer. Specify the payload keyword
to loop the data toward the network after the framer has processed the data.
■
remote—Sends a far end alarm code in the C-bit framing, as defined in
ANSI T1.404, to notify the remote end to activate or (when you use the
no
version) deactivate the line loopback
Mode
Controller Configuration
path ds3 loopback
■ 157
Chapter 4: P Commands