Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Справочник по командам

Страница: 189 / 1488

path ds1 fdl carrier
Syntax
[ no ] path pathChannel ds1 tributaryIdentifier fdl carrier
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Specifies that a DS1 signal is used in the carrier environment. This command applies
to a DS1 over channelized SONET or SDH interface. The
no version restores the
default situation, in which an interface does not operate in the carrier environment.
Options
pathChannel —Number, in the range 1–2147483648, that identifies the path
■
■
tributaryIdentifier —Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload / tributaryGroup / tributaryNumber
■
pathPayload —Payload number for the path; value is 1 for SONET and in the
range 1–3 for SDH
■
tributaryGroup —Number, in the range 1–7, that identifies the group within
the path
■
tributaryNumber —Number of the tributary within the tributary group; the
value is in the range 1–4 if the tributary type is vt15 or tu11 and in the range
1–3 if the tributary type is tu12
Mode
Controller Configuration
path ds1 fdl carrier
■ 147
Chapter 4: P Commands