Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Справочник по командам

Страница: 160 / 1488

ospf log-adjacency-changes
Syntax
[ no ] ospf log-adjacency-changes
[ severity {
severityValue | severityNumber } ] [ verbosity verbosityLevel ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Configures the router to send a system log message when the state of an OSPFv2
neighbor changes. For OSPFv3 neighbors, use the log-adjacency-changes command.
The
no version turns off this feature.
Options
severity—Minimum severity of the log messages displayed for the selected
category; described either by a descriptive term—
severityValue —or by a
■
corresponding number— severityNumber —in the range 0–7; the lower the number,
the higher the priority:
■
emergency or 0—System unusable
■
alert or 1—Immediate action needed
■
critical or 2—Critical condition exists
■
error or 3—Error condition
■
warning or 4—Warning condition
■
notice or 5—Normal but significant condition
■
info or 6—Informational message
■
debug or 7—Debug message
■
verbosityLevel —Specifies the verbosity of the log category’s messages; can be
any of the following:
■
low—Terse
■
medium—Moderate detail
■
high—Verbose
Mode
Router Configuration
118 ■
ospf log-adjacency-changes
JUNOSe 11.1.x Command Reference Guide N to Z