Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Справочник по командам

Страница: 191 / 1488

path ds1 fdl transmit
Syntax
[ no ] path pathChannel ds1 tributaryIdentifier fdl transmit
{ path-id | idle-signal | test-signal }
no path pathChannel ds1 tributaryIdentifier fdl transmit
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Configures the router to send the specified FDL message on a DS1 signal. This
command applies to a DS1 over channelized SONET or SDH interface. The
no version
stops the router from sending the specified FDL message or all FDL messages.
Options
■
pathChannel —Number, in the range 1–2147483648, that identifies the path
■
tributaryIdentifier —Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload / tributaryGroup / tributaryNumber
■
pathPayload —Payload number for the path; value is 1 for SONET and in the
range 1–3 for SDH
■
tributaryGroup —Number, in the range 1–7, that identifies the group within
the path
■
tributaryNumber —Number of the tributary within the tributary group; the
value is in the range 1–4 if the tributary type is vt15 or tu11 and in the range
1–3 if the tributary type is tu12
■
path-id—Transmits a path identification message every second; default value is
disabled
■
idle-signal—Transmits an idle signal message every second; default value is
disabled
■
test-signal—Transmits a test signal message every second; default value is
disabled
Mode
Controller Configuration
path ds1 fdl transmit
■ 149
Chapter 4: P Commands