28
250-0800-06, Version A
D I T E C H N E T W O R K S
w w w . d i t e c h n e t w o r k s . c o m
Getting Started
Packet Voice Processor Commands Manual
2.3.1 Provisioning Steps
describes the steps required to properly provision a Packet Voice
Processor system.
Table 2-3 PVP System Provisioning Procedures
Step
Procedure
Comments
1
Determine the hardware and software
requirements for the planned installation,
and obtain the hardware and software.
For installation planning and assistance, contact
Ditech Customer Service (refer to
2
Determine the required space and
environmental conditions for an
installation.
Refer to the
Packet Voice Processor Hardware
Manual
(as listed on
) for assistance in
determining the space and environmental
requirements for the Packet Voice Processor
installation.
3
Setup the Packet Voice Processor
hardware.
Refer to the
Packet Voice Processor Hardware
Manual
(as listed on
) for assistance in
setting up the Packet Voice Processor hardware.
4
Access the Packet Voice Processor
system.
Establish a connection to the active Switch Control
card. Access to the active Switch Control card is
through the console port located on the card’s front
panel.
Note: Use the serial port when first configuring a
Packet Voice Processor system. A single system
management Ethernet port is provided on the back
of the Packet Voice Processor shelf chassis via the
Rear Transition Module (RTM).
The process for connecting to the system
management port is described in
“Connecting to the PVP”, on page 23
.
5
Provision the system management port.
Provision the system management port.
Section 3.2, “System Management
for additional
information.
Table 3-1, “System Management Port Provisioning
Commands”, on page 35
lists the commands
required for this procedure.
6
Provision the Out-of-Band (OOB) signaling
port.
Provision the OOB signaling port located on the
active Switch Control card.
Section 3.3, “OOB Ports Signaling
for additional
information.
Table 3-3, “OOB Signaling Port Provisioning
Commands”, on page 38
lists the commands
required for this procedure.
7
Provision the Gigabit Ethernet media
ports.
Provision the Gigabit Ethernet ports located on the
Interface Processing cards.
Section 3.4, “Ethernet (Media) Ports
for additional
information.
Table 3-5, “Media Ports Provisioning Commands”,
on page 40
lists the commands required for this
procedure.
8
Provision voice quality for the Packet
Voice Processor system.
for additional
information.
Table 4-1, “Voice Quality Provisioning
Commands”, on page 43
lists the commands
required for this procedure.
Содержание Packet Voice Processor
