DITECH Packet Voice Processor, Руководство по управлению

Страница: 175 / 175

System Commands
250-0800-06, Version A 141
D I T E C H N E T W O R K S
w w w . d i t e c h n e t w o r k s . c o m
10
System
Co
mma
nds
Packet Voice Processor Commands Manual
10.6.5 LAG ADD Command
The LAG ADD command adds a new LAG interface. The required minimum access
level is Write for this command. The command syntax is as follows:
LAG ADD
Example 10-26 below displays an example of this command.
Example 10-26 LAG ADD Command
PVP> LAG ADD
New Lag Index - [2],3,4,5,6,7,8 :
====== Setup Dialog: Navigate with arrow keys, Ctrl-C to abort ======
Key - [2] :
Next Hop Device IP (for link redundancy) - [0.0.0.0] : 10.67.1.140
OK TO USE - Yes,No : Yes
Provisioned.
Note Table 10-14 on page 140 describes the parameters for this command.
Note The Next Hop Device IP value in the above command example is only used for
supporting a VRRP redundant router protection scheme.
10.6.6 LAG PING
The LAG PING command sends PING on the LAG interface. Ping verifies whether a
particular IP address exists and can accept requests. The LAG PING command can
be used to help debug network connection problems.The required minimum access
level is Read for this command. The command syntax is as follows:
LAG PING [<interval>] [<pattern>] [<packetsize>] <pinghost>
Table 10-15 describes the arguments used for this command.
Table 10-15 LAG PING Command
Command Argument Description
<interval> Ping Interval - always prefix with I/i (for example, I1.5/i10).
<pattern> Ping Pattern - always prefix with P/p (for example, Pabcd/pabcd).
<packetsize> Packet Size - always prefix with S/s (for example, S56/s1016).
<pinghost> Ping Host - IP address