Danfoss VLT Integrated Servo Drive ISD 510 System, Руководство по эксплуатации

Страница: 49 / 226

•
•
•
•
•
•
•
1.
2.
3.
4.
5.
1.
2.
3.
4.
4.5.2 ISD 510/DSD 510 Servo Drive
The allowable operating ambient temperature range and vibration levels must not be exceeded. (See 11.10.1 ISD 510/DSD 510
Servo Drive .)
The allowable relative humidity range is 3–93%, non-condensing.
Unrestricted ventilation must be available.
The mounting structure must be suitable for the application, for example, adequately rigid and able to cope with temperatures
over 90 °C.
4.5.3 System Modules
The environmental conditions for the PSM 510, DAM 510, and ACM 510 are:
The allowable operating ambient temperature range and vibration levels must not be exceeded (see 11.10.2 System Modules ).
The allowable relative humidity range is 5–93%, non-condensing.
The minimum space required above and below the system modules is detailed in
4.7.3 Space Requirements for System Modules .
4.6 Preparation for Installation
4.6.1 ISD 510/DSD 510 Servo Drive
Make the following preparations to ensure that the servo system can be installed reliably and effectively.
Always fit couplings and other transfer components in accordance with local regulations.
Procedure
Provide a suitable mounting arrangement for the application. This depends on the type, weight, and power size of the ISD
510/DSD 510 servo drives.
For the ISD 510 servo drives, seat the motor flange flush against the mounting surface before fixing the servo drive. Mis-
alignment shortens the life of the bearings and the coupling components and reduces heat transfer from the servo drive.
For the DSD 510 servo drives, seat the bottom side of the DSD 510 to the mounting surface before fixing the servo drive.
Misalignment reduces heat transfer from the servo drive.
Provide contact protection according to local regulations if hot surfaces can be expected during operation.
Ground the servo drive.
4.6.2 System Modules
Make the following preparations to ensure that the servo system can be installed reliably and effectively.
Always fit the system modules in accordance with local regulations.
Procedure
Provide a suitable mounting arrangement for the application. This depends on the type and weight of the modules.
To avoid misalignment, ensure that the backplates are perfectly level.
To ensure sufficient cooling, pay attention to the specified minimum space requirements.
Ground the modules.
AQ262449648484en-000101 / 175R1135 | 49 Danfoss A/S © 2020.08
Mechanical Installation
VLT® Servo Drive System ISD 510/DSD 510
Operating Guide