Danfoss iC2, Инструкция по применению

Страница: 33 / 292

Application Guide | iC2-Micro Frequency Converters
e3
0b
v1
45
.1
0
5.5.4.1 Ramp 1 Type Selec
5.5.4.2 Ramp 1 Accel. Time
LOC 0.0 Hz 1(1)
Ramp
Figure 14: Changing Selections in a Parameter
1. To view the selections of the parameter, press
OK
. The selections available for the parameter is shown. A tick icon in the front of the
selection indicates the selected choice.
e3
0b
v1
46
.1
0
0 Linear
1 Sine Ramp
LOC 0.0 Hz 1(1)
Ramp 1 Type Selector
Figure 15: Selections in a Parameter (Example)
2. Use the
up
or
down
arrow to browse through the selections.
e3
0b
v1
47
.1
0
0 Linear
LOC
1 Sine Ramp
0.0 Hz 1(1)
Ramp 1 Type Selector
Figure 16: Browsing through the Selections (Example)
3. Press
OK
at the required selection. The tick icon is moved to this selection.
e3
0b
v1
48
.1
0
0 Linear
LOC
1 Sine Ramp
0.0 Hz 1(1)
Ramp 1 Type Selector
Figure 17: Confirming the Selections (Example)
3.2.6.6
Changing Parameter Value
In the example, the parameter P 5.5.4.2 Ramp 1 Accel. Time is considered and Figure 18 show the change of value from 3 s to 5 s.
1. Go to the
parameter P 5.5.4.2 Ramp 1 Accel. Time
and press the
OK
button.
2. Press the
OK
button again to enter value edit screen. To go to the values before or after the decimals, use the
left
or
right
arrow button.
A black highlight on the digit indicates the location where the cursor is active.
3. Use the
up
or
down
arrow button of the Control Panel 2.0 OP2 to increase or decrease the value.
4. Press
OK
to confirm the changes.
Figure 18 shows all the screens relevant to change the value of a parameter.
Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254 |
33