S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
20-27
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
OL-9285-05
Chapter 20 Troubleshooting IP Storage Services
FCIP Issues
Trunk vsans (up) (1-2)
Trunk vsans (isolated) ()
Trunk vsans (initializing) ()
Using Profile id 21 (interface GigabitEthernet2/1)
Peer Information
Peer Internet address is 10.10.10.2 and port is 3225
Special Frame is disabled
Maximum number of TCP connections is 2
Time Stamp is disabled
B-port mode disabled
TCP Connection Information
2 Active TCP connections
Control connection: Local 10.10.11.2:65330, Remote 10.10.10.2:3225
Data connection: Local 10.10.11.2:65332, Remote 10.10.10.2:3225
Displaying Passive Mode Set on Both Sides of the FCIP Tunnel with the CLI
In the following example, passive mode is set on both sides of the FCIP tunnel.
module-2# Mar 14 23:49:06 port1: 1870:FCIP21: SUP->
Set Port mode 1
Mar 14 23:49:06 port1: 1871:FCIP21: SUP-> Port VSAN (1) already set to same value
Mar 14 23:49:06 port1: 1872:FCIP21: SUP-> Trunk mode (1) already set to same value
Mar 14 23:49:06 port1: 1873:FCIP21: SUP-> Enable tunnel ADMIN UP
Mar 14 23:49:06 port1: 1874:FCIP21: Try to Bring UP the Tunnel
Mar 14 23:49:06 port1: 1875:FCIP21: Start TCP listener with peer: 10.10.10.2:3225
Mar 14 23:49:06 port1: 1876:FCIP: Create a new listener object for 10.10.11.2:3225
Mar 14 23:49:06 port1: 1877:FCIP: Create FCIP Listener with local info: 10.10.11.2:3225
Mar 14 23:49:06 port1: 1878:FCIP21: Passive mode set, don't initiate TCP connection
(A TCP connection will not be established when passive mode is set.The Gigabit Ethernet port will only
listen.)
MDS2#
show interface fcip 21
fcip21 is down (Link failure or not-connected)
Hardware is GigabitEthernet
Port WWN is 20:42:00:0b:5f:d5:9f:c0
Admin port mode is auto, trunk mode is on
vsan is 1
Using Profile id 21 (interface GigabitEthernet2/1)
Peer Information
Peer Internet address is 10.10.10.2 and port is 3225
Passive mode is enabled
(Passive mode is set, so a TCP connection will not be established.)
Special Frame is disabled
MDS1#
show interface fcip 21
fcip21 is down (Link failure or not-connected)
Hardware is GigabitEthernet
Port WWN is 20:42:00:05:30:00:59:de
Admin port mode is auto, trunk mode is on
vsan is 1
Using Profile id 21 (interface GigabitEthernet2/1)
Peer Information
Peer Internet address is 10.10.11.2 and port is 3225
Passive mode is enabled
(Both sides are set to passive mode. You must change one or both sides to
no passive-mode
under the
FCIP interface.)
Special Frame is disabled
MDS2(config)#
interface fcip 21
MDS2(config-if)#
no passive-mode
