Canon imagePRESS 1110, Руководство по обслуживанию

Страница: 439 / 1603

4
4
4-175
4-175
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Replacing Primary Charging Wire (left)
Parts Replacement and Cleaning > Periodic Replacing Parts, Durable Parts, Cleaning Parts > Replacing Primary Charging Wire (left)
8) Clean the grid surface (front and back) of primary charging assembly with lint-free paper moistened with alcohol.
Grid surface (back)
Grid surface (front)
F-4-342
9) Since the primary charging assembly is replaced on charging wire basis, use the dedicated
torsion spring for charging wire (97-5527) [A].
Caution :
Be careful not to use the
spring [B] installed to the
primary charging wire (right)
unit.
Spring [A] Spring [B]
F-4-343
10) Unroll the charging wire by approx. 5cm from the charging wire reel of 0.06mm wire diameter
and make a loop with 2mm diameter at the end.
MEMO :
To make a loop easily, wind the charging wire on the hex key once, turn the hex key 3
to 4 times and twist the charging wire.
11) Cut the edge (extra wire) of the twisted charging wire with a nipper etc.
12) Hook the loop on the stud.
(FRONT) (REAR)
Charging wire reel
Charging wire
Stud
F-4-344