Asentria TeleBoss 830, Руководство пользователя

Страница: 133 / 157

TeleBoss 830 2.11.370 STD User Manual
Page 133
EventSensor: the number of the EventSensor that has the specified output, where it is the same as that
referred to by the index in an EventSensor key (e.g., 200 for an internal EventSensor) as well as that
referred to by the SNMP esIndex object.
Point: the number of the output (1-based) on the specified EventSensor.

POWER(ACTION, EVENTSENSOR, POINT)
Relay
Put a relay in a certain state specified by the action indicator.
Action: one of the following two words, by case-insensitive exact match or partial unambiguous match:
ACTIVE or INACTIVE
. “Active” means to put the relay in the active Event State. For a relay this could be
energized or de-energized depending on the relay configuration.
EventSensor: the number of the
EventSensor that has the specified relay,
where it is the same as that referred to by
the index in an EventSensor key (e.g., 2
an EventSensor (expansion card) in slot
2).
Point: the number of the relay (1-based)
on the specified EventSensor.

RELAY(ACTION, EVENTSENSOR, POINT)
SMS
Send an SMS message to a specific phone number or index which refers to a phone number configured in the
Action Definitions menu/ Phone Number section.

SMS(PHONE# or INDEX#)
Syslog
Send a syslog message (via UDP port 514) to the specified address. The facility and level parameters are
optional numbers but both must be supplied if either is necessary. The default facility is 1 ("user") and the
default level is 6 ("informational").

SYSLOG(IPADDRESS or INDEX#, optional FACILITY,LEVEL)
Talert
Send a talert (Asentria Alarm via TCP) to a server identified by a hostname index defined in Action Definitions
menu Hostname/IP Address section or by an IP address specified in the action list.

TALERT(IPADDRESS or INDEX#)
Trap
Sends an SNMP Trap to a server identified by a hostname index defined in the Action Definitions menu
Hostname/IP Address section, or by an IP address specified in the actions list.

TRAP(IPADDRESS or INDEX#)

To send an SNMPv3 trap, the correct syntax is: TRAP(INDEX/IPADDRES,3)