3D Systems, Inc.
71
p/n: 15-D100, rev. D
14. Unbolt the door. In the adjacent figure, the bolts are
highlighted red for clarity.
15. Start at the bolt in the upper right corner and turn one
time. Proceed counter-clockwise to the next one and turn
that one, continue one by one until you have loosened
every bolt one turn.
16. Continue going from bolt to bolt, loosening a little more
each time you make the round. When all bolts are loose,
click on
Confirm bolts are unscrewed
. This will bring the
process chamber to atmospheric pressure.
17. A pop-up window on the PC will confirm you can open the
door.
13. Click the
Start unlocking
button.
18. Loosen the 4 corner bolts with a 5 mm hex key to remove
the build plate.
Note: Make sure to store the hex bolts for later
use.
Caution: the build plates are quite heavy. Adding
newly built parts to that weight, makes them even
heavier. Pay attention not to pinch your fingers
when taking out the part.
Caution: Hitting the printer module with heavy
metal objects, for example a build plate, may
cause the printer module to magnetize. This may
influence the powder and thus build quality. Avoid
hitting the printer module with metal objects at
all time.
Содержание DMP Flex 350
Страница 1: ...DMP Flex 350 Production printer User guide Original instructions ...
Страница 11: ...3D Systems Inc 6 p n 15 D100 rev D 1 x on the printer door 1 x on the scanner 2 1 4 Laser Safety Label ...
Страница 119: ...3D Systems Inc 114 p n 15 D100 rev D 8 BASIC REGULATIONS 8 1 EC Declaration of Conformity DoC ...