3D Systems DMP Flex 350, Руководство пользователя

Страница: 50 / 120

3D Systems, Inc. 45 p/n: 15-D100, rev. D
4.5.3 Menu Bar
A. File
• Exit: Click to close down the DMP Deposition software.
B. Controllers
• Test signal tower lights : Click to open the window to test
the lights in the stack light. Use the check boxes to switch
the lights on/off. When the window is closed, the light
stack will go back to its original state.
• Verify if ready for processing : Click to verify if the DMP
Factory 350 is ready to start a job. During this cycle a set
of parameters will be checked to see if the system is fully
prepared to start a print job.
• List PLC details : Click to open a pop-up window with details
on the PLC used in the system.
• List safety PLC details : Click to open a pop-up window with
details on the safety PLC used in the system.
• Run filter prepare cycle : Click to open the Bring filter to a
safe state pop-up window. Click Start to bring the filter to a
safe state after it has been replaced or after a long period
of inactivity. Click the check box Combine with machine
preparation cycle to start a preparation cycle immediately
afterwards.
• Touch behavior :
• Select Optimized for mouse when working with a
mouse connected to the pc through one of the USB
ports on the printer control panel.
• Select Optimized for touchscreen when working only
via the touchscreen.