Vanderbilt SPC4 Series, Installation & Configuration Manual, Page: 4 / 402

6.1 Mounting a G2 housing 43
6.2 Mounting a G3 housing 44
6.2.1 Mounting a Back Tamper Kit 46
6.2.2 Battery installation for EN50131 compliance 50
6.3 Mounting a G5 housing 51
6.3.1 Tamper protection 52
6.3.2 Mounting the housing with tamper protection 53
6.3.3 Installing the batteries 55
6.4 Mounting a keypad 56
6.5 Mounting an expander 56
7 Smart PSU 57
7.1 SPCP355.300 Smart PSU 57
7.1.1 Supervised Outputs 59
7.1.2 Batteries 60
7.1.3 Wiring the X-BUS Interface 62
7.1.4 Compliance with NF and A2P approvals including CYBER requirements 65
7.1.5 PSU LED Status 66
7.1.6 System Recovery 66
8 Controller hardware 68
8.1 Controller Hardware 42xx/43xx/53xx/63xx 68
8.2 Controller Hardware SPC5350 and 6350 71
9 Door Expander 74
10 Wiring the system 75
10.1 Wiring the X-BUS interface 75
10.1.1 Loop configuration 76
10.1.2 Spur configuration 77
10.1.3 Star and multi-drop configuration 78
10.1.4 Shielding 83
10.1.5 Cable Map 83
10.2 Wiring of branch expander 83
10.3 Wiring the system ground 84
10.4 Wiring the relay output 84
10.5 Wiring the zone inputs 85
10.6 Wiring an external SAB bell 88
10.7 Wiring an internal sounder 89
10.8 Wiring Glassbreak 89
10.9 Installing plug-in modules 90
11 Powering up the SPC controller 92
11.1 Powering from battery only 92
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Table of Contents
© Vanderbilt 2018 4 A6V10276959-d
11.2018