BR0IN-05
F13334
F13335
BR-26
-
BRAKE
FRONT BRAKE PAD
1369
Author:
Date:
2001 SIENNA (RM787U)
REPLACEMENT
1.
REMOVE FRONT WHEEL
Remove the wheel and temporarily fasten the disc with the hub
nuts.
2.
INSPECT PAD LINING THICKNESS
Check the pad thickness through the caliper inspection hole
and replace the pads if they are not within specification.
Minimum thickness: 1.0 mm (0.039 in.)
3.
LIFT UP CALIPER
(a)
Hold the sliding pin on the bottom and loosen the installa-
tion bolt, and remove the installation bolt.
(b)
Lift up the caliper and suspend it securely.
HINT:
Do not disconnect the flexible hose from the caliper.
4.
REMOVE 2 BRAKE PADS WITH 4 ANTI- SQUEAL
SHIMS
5.
REMOVE 4 PAD SUPPORT PLATES
NOTICE:
The support plates can be used again provided that they
have sufficient rebound, no deformation, cracks or wear,
and have had all rust, dirt and foreign particles cleaned off.
6.
REMOVE PAD WEAR INDICATOR PLATE FROM IN-
NER PAD
7.
CHECK DISC THICKNESS AND RUNOUT
(See page
8.
INSTALL PAD SUPPORT PLATES
Install the 4 pad support plates.
9.
INSTALL NEW PADS
NOTICE:
When replacing worn pads, the anti-squeal shims and pad
wear indicator plates must be replaced together with the
pads.
