P13481
Ohmmeter
No Continuity
B01162
Lock
Free
B01224
B01225
ST-10
-
STARTING
STARTER
1228
Author:
Date:
2001 SIENNA (RM787U)
11.
INSPECT BRUSH HOLDER INSULATION
Using an ohmmeter, check that there is no continuity between
the positive (+) and negative (-) brush holders.
If there is continuity, repair or replace the brush holder.
12.
INSPECT GEAR TEETH
Check the gear teeth on the pinion gear, idler gear and clutch
assembly for wear or damage.
If damaged, replace the gear or clutch assembly.
If damaged, also check the drive plate ring gear for wear or
damage.
13.
INSPECT CLUTCH
Hold the starter clutch and rotate the pinion gear counterclock-
wise, and check that it turns freely. Try to rotate the pinion gear
clockwise and check that it locks.
If necessary, replace the clutch assembly.
14.
IF NECESSARY, REPLACE CLUTCH ASSEMBLY
(a)
Disassemble the starter housing and clutch assembly.
(1)
Mount a brass bar in a vise, and install the starter
housing and clutch assembly to the brass bar.
(2)
Push down the pinion gear.
(3)
Using a plastic-faced hammer, tap down the stop
collar.