F02210
LH
RH
F02211
F02212
-
SUSPENSION AND AXLE
FRONT DRIVE SHAFT
SA-17
1304
Author:
Date:
2001 SIENNA (RM787U)
8.
REMOVE LH DRIVE SHAFT
(a)
Using a brass bar and hammer, remove the drive shaft.
HINT:
At the time of installation, please refer to the following items.
Coat gear oil to the inboard joint shaft and differential
case sliding surface.
Before installing the drive shaft, set the snap ring with its
opening side facing downward.
Keeping inboard joint shaft in contact with pinion shaft or
not can be known from the sound or feeling.
After installation, check that there is 2 - 3 mm (0.08 - 0.12
in.) of play in the axial direction.
After installation, check that the drive shaft cannot be re-
moved by hand.
(b)
Using a screwdriver, remove the snap ring from the in-
board joint shaft.
9.
REMOVE RH DRIVE SHAFT
(a)
Remove the bearing lock bolt.
Torque: 32 N·m (330 kgf·cm, 24 ft·lbf)
(b)
Using pliers, remove the snap ring.
(c)
Remove the drive shaft.
HINT:
At the time of installation, coat gear oil to the inboard joint shaft
and differential case sliding surface.
