Toyota 2007 Highlander, Owner'S Manual

Page: 298 / 439

’07 HIGHLANDER_U (L/O 0608)
274
2007 HIGHLANDER from July ’06 Prod. (OM48682U)
The ceiling mounted garage door opener
motor should now recognize the
HomeLink # unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 for each re-
maining HomeLink # button to program
another rolling code system.
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink # but-
tons you want to program.
2. Place your hand − held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface of the
HomeLink # .
Keep the indicator light on the HomeLink #
in view while programming.
3. Press and hold the selected
HomeLink # button.
4. Continuously press and release (cycle)
the hand − held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light on the
HomeLink # changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink # by
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink
#
button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink # buttons cannot be
erased, however, to reprogram a single
button, follow the procedure “Programming
the HomeLink # ”.
(b) Operating the HomeLink #
To operate the HomeLink # , press the
appropriate HomeLink # button to activate
the programmed device. The HomeLink #
indicator light should come on. The
HomeLink
# continues to send the signal
for up to 20 seconds as long as the
button is pressed.
(c) Erasing the entire HomeLink #
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink #
memory.
For additional programming assistance
with
your HomeLink # Universal
Transceiver call the:
"
Toyota Customer Experience Center at
1 − 800 − 331 − 4331 (U.S.A.)
"
Toyota Canada Customer Interaction
Centre at 1
− 888 − 869 − 6828 (Canada)