Toshiba Strata AirLink DK40i, Installation And Maintenance Manual

Page: 496 / 724

Station Apparatus
PC Attendant Console
11-46
Strata DK I&M 6/00
3. Choose the processor type for the
connected DK424 system (RCTUB
or RCTUC/D).
4. Select the DK software version of
the system (R2, R3 or higher).
5. Enter emergency numbers as
programmed in Program 44-91~93
of the DK424.
6. Click the Default Configuration
button. This will set all the
parameters to match the default
values of the DK424.
Important!
It is extremely important
to match the parameters
set in the DK424 with
those in the Telephony
Setup or the PC attendant console will not know how to operate properly. Before
Step 7, go through each of the following telephony setup programs. ALL changes in
these following screens must match the corresponding values in the programming of
the DK424.
7. The Default Configuration button will close the DK424 PC Attendant Configuration screen.
To make changes, select Setup again, then continue.
Default Key Assignments
From the DK PC Attendant Configuration screen, the Configure Keys button takes you to the DK
PC Attendant Key Configuration screen.The default key assignments are defined for R2 and R3.
These key assignments must match Program 59 of the DK. The Default Config button on this
screen sets the default keys only, whereas the Default Config button on the previous screen sets the
system database defaults.
➤
To assign PC Attendant keys
1. From the PC Attendant
Configuration dialog box, select
the key that you want to change.
The Key Type drop-down box
shows a list of key names that can
be selected for that button. The
three-digit program codes are
shown in front of the button for
convenient programming. If the
programming telephone is next to
the PC attendant console, you can
look at the codes on the PC
Attendant screen while you
program.
2. Click OK after making your
selections.
1024
1026