Toshiba Strata AirLink DK40i, Installation And Maintenance Manual

Page: 24 / 724

DK14 Installation
Site Requirements
1-2
Strata DK I&M 6/00
Input Power
The system requires an input power source of 115VAC ± 10VAC, 50/60 Hz, 10 amps. The AC
outlet is recommended to be dedicated and unswitched, with a solid third-wire ground. (See
“AC
Power and Grounding Requirements” on Page 1-3 for details).
This is to eliminate interference from branch circuit motor noise or the like, and to prevent
accidental power-off. To avoid accidental power turn-off, Toshiba recommends that you do
not use
an On/Off wall switch on this dedicated AC circuit.
For the DK14, a reserve power source (two customer-supplied 12-volt batteries) may be connected
to the system to serve as a power failure backup.
Clearance and Location
The minimum clearance requirements for the DK14
KSU are shown in
Figure 1-1 . The HPFB should be
mounted directly above the D14 KSU.
Consider the following conditions when selecting a
location for the KSU(s):
The location must be :
♦
Dry and clean
♦ Well ventilated
♦
Well illuminated
♦ Easily accessible
The location must not be :
♦ Subject to extreme heat or cold
♦
Subject to corrosive fumes, dust, or other
airborne contaminants
♦ Subject to excessive vibration
♦
Next to television, radio, office automation, or
high frequency equipment
2"
2"
16.4"
Front View
Top View
3"
3' Front Clearance
Wall
2"
DK14 KSU
HPFB
2" 2" 10"
2399
Figure 1-1 DK14 KSU Clearance
Requirements