Toshiba Strata AirLink DK40i, Installation And Maintenance Manual

Page: 492 / 724

Station Apparatus
PC Attendant Console
11-42
Strata DK I&M 6/00
➤
To install the PC attendant console
See Figure 11-28 and follow these steps:
1. Connect the RATI to the PC COM port a with a standard RS-232 cable.
2. Use one-pair wiring to connect the MDF to an RJ11 jack at the attendant console location. If
you need to use a long cable, use two-pair for more power.
3. Plug in the handset cradle to the RJ45-jack.
4. Plug in the headset (if needed) to the handset base.
5. After programming the Strata DK system, install the PC attendant console software and
complete the Telephony Setup per the instructions on “PC Attendant Console Software
Installation” on Page 11-44 .
Figure 11-28 RATI Assembly/Disassembly
Notes
●
Do not cut HEADSET jumper unless you are connecting two headsets.
●
Cut CARBON jumpers if a carbon handset is connected to the RATHC handset cradle.
●
“REC OUT” can be used to monitor or record the attendant console talkpath. Both the
attendant and connected party will be monitored or recorded. The record level output from the
attendant handset or headset is approximately 3 dB below the connected party record level.
Use a 1/8” mini audio jack.
POW DTR DSR
RATI (Front View)
Bottom Panel
RATI PCB
Carbon Jumper
Headset Jumper
DB9-FEMALE
(To PC COM Port Cable)
RJ11-JACK
(To RATU Modular Cord)
RJ45-JACK
(To RATHC Modular Cord)
REC OUT
(To Tape Recorder "RECORD" Input)
AUX IN
(Not Used)
1497