Toro Reelmaster 5510 Series, Service Manual

Page: 638 / 662

Disassembling the Height Adjuster Assembly (continued)
6. Disassemble the height adjuster assembly ( Figure 401 ).
7. Clean all the components and inspect for wear or damage. Replace all the
components that are worn or damaged.
Assembling the Height Adjuster Assembly
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly
(
Figure 401 ).
2. If both the height adjusters are removed, fit 1 height adjuster assembly to the
cutting unit side plate and secure it with the flange-head bolt and flange nut.
Do not tighten the flange nut at this time. Ensure that the height adjustment
bolt and 1 washer is above the slot in the side plate and 1 washer and locknut
is below the slot in the side plate.
3. Position front roller between the height adjuster assemblies and secure
height adjuster assembly to cutting unit side plate with flange-head bolt and
flange nut. Do not tighten the flange nut at this time. Ensure the height
adjustment bolt and 1 washer is above slot in side plate and 1 washer and
locknut is below slot in side plate.
4. Install new cotter pins and clevis pins and secure the height adjustment rods
to the groomer gear box and idler arm.
5. Adjust the cutting unit height-of-cut; refer to Cutting Unit Operators Manual .
6. Check the groomer reel height and adjust as necessary.
g237055
Figure 402
1. Height adjustment knob
7. Thread the pinch bolts (item 21 in Figure 401 ) to 6.6 to 12.7 mm (0.26 to 0.5
inch) into the height-of cut bracket until the springs on the groomer height
adjustment rods are compressed to 54 mm (2.13 inches).
Universal Groomer (Optional): Service and Repairs Page 11–18 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C