Toro Reelmaster 5510 Series, Service Manual

Page: 328 / 662

Assembling the Cutting Reel Motor (continued)
IMPORTANT
When you clamp the motor in a vise, clamp the front flange only to
prevent damage. Also, use a vise equipped with soft jaws.
17. Clamp the front flange of the motor in a vise equipped with soft jaws.
18. Alternately torque the bolts to 45 N∙m (33 ft-lb) .
19. On Reelmaster 5510 and 5610 series reel motor, install the cross-over relief
valves into the rear flange if they were removed; torque the relief valves
to
25 N∙m (18 ft-lb) .
20. Remove the motor from the vise.
21. Put a small quantity of clean hydraulic fluid in the inlet of the motor and rotate
the driveshaft away from the inlet for 1 revolution. If there is any binding,
disassemble the motor and check for assembly problems.
Hydraulic System: Service and Repairs Page 6–210 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C