Toro Reelmaster 5510 Series, Service Manual

Page: 114 / 662

Removing the Engine
1. Park machine on a level surface, lower cutting units, stop engine and remove
key from the key switch. Chock wheels to keep the machine from moving.
2. Unlatch screen at rear of machine. Lift screen from hinges and remove
screen from machine.
3. Disconnect negative (-) and then positive (+) battery cables from battery;
refer to Servicing the Battery (page 7–125) .
4. If engine is to be disassembled, drain oil from engine.
5. Open and support hood.
CAUTION
Do not open radiator cap or drain coolant if the radiator or engine is
hot. Pressurized, hot coolant can escape and cause burns.
Ethylene-glycol antifreeze is poisonous. Dispose of coolant properly,
or store it in a properly labeled container away from children and
pets.
6. Drain coolant from radiator; refer to Radiator and Oil Cooler Assembly (page
5–17) .
7. Remove air cleaner from machine; refer to Air Cleaner Assembly (page 3–8) .
8. Remove exhaust system from machine; refer to Exhaust System (page 3–11) .
9. Disconnect hoses from engine:
A. Loosen hose clamps and then remove upper and lower radiator hoses
from the engine.
g229349
Figure 54
1. Negative battery cable 3. Bolt 5. Harness retainer
2. Wire harness ground 4. Flange nut
B. Disconnect fuel supply and return hoses from engine ( Figure 54 ).
Position fuel hoses away from engine.
C. Plug disconnected hoses and engine openings to prevent leakage and
contamination. Position disconnected hoses away from engine.
Kubota Gasoline Engine: Service and Repairs Page 5–22 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C